Electric two - way ball valve
詳情介紹
product description
Electric two - way ball valve
Main Material
| Part name | material description |
| valve body | nickel plated brass，304，316 |
| valve ball | Chrome plated brass，304，316 |
| valve rod | brass，304，316 |
| pedestal | PTFE |
| sealing element | EPDM |
The main features
1, small size, suitable for small equipment
2, floating sealing structure, not easy to die, can be used for a long time without action occasions.
3. Nominal service life
4, low running current, can use battery power
5. Protection level IP67, F type optional *2
Use occasions
1. Water-saving appliances (university card water-saving system)
2, replace the ordinary solenoid valve, especially the solenoid valve can not work reliably
3. Prepaid hot and cold water meter
4, environmental protection, water supply and drainage, water treatment engineering
5. Industrial automatic control and other small equipment
The discharge coefficient
HX20 full-size ball valve connection size unit: mm
| caliber | D1/D2 | d | L1/L2 | L3 | F | H1 | H2 | W(kg) |
| DN8 | G1/4" | 8 | 11 | 43 | 17 | 11 | 18.25 | 0.26 |
| DN10 | G3/8" | 10 | 11.5 | 50 | 20 | 12.5 | 19.75 | 0.31 |
| DN15 | G1/2" | 15 | 13 | 57 | 27 | 16.5 | 21.25 | 0.37 |
| DN20 | G3/4" | 20 | 16 | 70 | 32 | 21.5 | 25.75 | 0.52 |
Note: without the bracket, the total height minus 7mm.
HX20 reduced diameter ball valve connection size unit: mm
| 口徑 | D1/D2 | d | L1/L2 | L3 | F | H1 | H2 | W(kg) |
| DN20 | G3/4" | 15 | 15 | 64.5 | 30 | 16.5 | 21.25 | 0.37 |
| DN25 | G1" | 20 | 18 | 76 | 38 | 21.5 | 24.75 | 0.52 |
| DN32 | G1-1/4" | 20 | 20 | 80 | 48 | 24 | 24.75 | 0.70 |
Note: 1. The external dimensions for non-manual operation are the same as those for manual operation, except the appearance is slightly different (the handwheel is the main difference).
2, HX20 reduced diameter ball valve caliber DN32 only brass material is optional.
Matters needing attention:
*1 the service life is measured at pressure of 1.0mpa, flow rate of 200L/h, and medium is tap water. Different service environments have an impact on the service life.
*2 type F should be used in the case of long-term moisture but no danger of flooding. Type F shall not be cut off after the valve is in place.
* type 3F product must be installed with the drain hole facing the ground and the sealant cap removed before use.